All Results (1.940)

Camera Lenses This is the 6mm CS-mount wide angle lens from CGL Electronics Co. Ltd. for use with the Raspberry Pi HQ Camera Module. The lens produces a 3MP picture in a 0.5in image format and is easily interchangeable using the thumb screw and adapter included wi

SparkFun Accessories This 3ft Category 6 (CAT 6) Ethernet cable is the solution to your internet working needs. With a speed of up to 500MHz you can connect to your LAN/WAN segments and networking gear at maximum speed. Also with its superior connector you get a cable t

SparkFun Accessories 1/6th Watt +/- 5% tolerance PTH resistors. Commonly used in breadboards and perf boards these 330Ohm resistors make excellent LED current limiters and are great for general use. Need more than one? Checkout our bags of resistors.

SparkFun Accessories Check out these big 10mm through-hole LEDs! The opaque epoxy package causes these LEDs to have a soft diffuse glow.Features:620-625nm Red1.8-2.2VDC Forward Voltage20mA Forward Current40 degree viewing angle100-150 MCD outputDocuments:[Datasheet](htt

SparkFun Accessories This is a through-hole 12mm coin cell battery holder. It's the unit we like to use as RTC backup and SRAM backup for GPS units. Holds battery in place with friction. Metal housing is + PCB pad underneath is -.This battery holder is sold in single un

SparkFun Accessories JST Right-Angle Connector TH 2-Pin

SparkFun Accessories This is an incredibly simple two cell 18650 Battery Holder. When someone thinks of 18650 Cells they tend to think of flashlights first which is fair since that is what they have been primarily used for. However with this battery holder you will gai

SparkFun Accessories Resistor 1M Ohm 1/4 Watt PTH - 20 pk

SparkFun Accessories Tip tinner is a good thing to have in your arsenal of soldering supplies. Composed of a mild acid it helps remove baked on residue (for when you melt your desk top) and helps prevent oxidation (the nasty black stuff) that accumulates on your solderi

SparkFun Accessories These are very small surface mount quartz crystals used where size is a concern. Ideal for use with the nRF2401 ICs. 20ppm * 18pF load capacitance

SparkFun Accessories LEDs - those blinky things. A must have for power indication pin status opto-electronic sensors and fun blinky displays.This is a very basic 5mm LED with a red lens. It has a typical forward voltage of 2.0V and a rated forward current of 20mA.

SparkFun Accessories For a long time we've had small 7-segment displays and *huge *7-segment displays but now we finally have something in between. These 20mm 4-digit 7-segment displays are big enough to see from a distance but not so big that you'd have trouble finding