Texas Instruments IWR1443BOOST mmWave Sensor Evaluation Module (EVM)
Texas Instruments IWR1443BOOST mmWave Sensor Evaluation Module (EVM) is an easy-to-use evaluation board for the IWR1443 mmWave sensor, with direct connectivity to the TI MCU LaunchPad™ ecosystem. The evaluation board contains everything required to start developing on a low-power ARM®-R4F controller. The evaluation board includes onboard emulation for programming and debugging, onboard buttons, and LEDs to integrate a simple user interface quickly. The standard 20-pin BoosterPack headers make the evaluation board compatible with a wide variety of TI MCU LaunchPads and enable easy prototyping. A 5V 2.5A supply brick with a 2.1mm barrel plug (center positive) is not included. An external power supply is recommended to be purchased that complies with applicable regional safety standards.
Features
- XDS110-based JTAG with a serial port interface for flash programming
- UART-to-USB interface for control, configuration, and data visualization
- TI Launchpad interface to seamlessly connect to TI MCUs
- CAN connector
- Powers from a single 5V supply
Kit Contents
- Micro USB cable
- Mounting brackets with Bumpon™
- M3-size screws
- M3-size nuts
- Jumpers
Related Products
Texas Instruments mmWave Sensors
Unprecendented accuracy, simplified sensing, and smaller design on a single chip.
Texas Instruments TCAN1042/Q1 Fault Protected CAN Transceivers
Designed to meet the ISO1189-2 High-Speed CAN (Controller Area Network) physical layer standard.
Texas Instruments TPS7A88 Low-Noise Low-Dropout Voltage Regulator
Flexibility of two LDOs and approximately 50% smaller solution size than two single-channel LDOs.
Texas Instruments LP8752x-Q1 Four-Phase 10A Buck Converters
Meets power management requirements for processors & platforms in automotive power applications.
Texas Instruments LM4040-N/-Q1 Micropower Shunt Voltage References
Ideal for space-critical applications, design effort reduced by several features.
Related Development Tools
Texas Instruments MMWAVEPOEEVM Evaluation Module
Supports Power over Ethernet (PoE) for the TI 60GHz to 64GHz mmWave sensors carrier card platform.